← charliekodatt.com
Anytown Comfort Co.
Home Air Report · Sample home, 2,100 sq ft, built 1998 · Two weeks of monitoring: a baseline week, then a week after the fixes
Demo company. Modeled on a home from an 8-home pilot; hourly readings are illustrative.

Your system was fine. Your air was too damp. Now it's back in range.

We measured your home's air for a full week before changing anything. That's your baseline: a starting point to compare against. Humidity sat around 73% all week, well above the 60% the EPA says to stay under. After the fixes, it stayed inside the range the EPA recommends.

Baseline weekWeek after fixesEPA recommended range, 30–50%Keep below 60%
Average indoor humidity
73%baseline week
→
47%after fixes
168 → 0hours above 60% (out of 168)
78.5% → 49.8%highest single reading

The two fixes: we sealed a leaking duct above the upstairs bathroom ceiling and set the system fan back to Auto. We also replaced a clogged filter.

How to read this report:In range meets the recommendationWatch close to the limitFix outside the recommendation

For operators reading this

This home's equipment passed every check. On a normal tune-up, the visit closes as "everything looks good," and the family keeps living at 73% humidity. A report like this turns a no-sale visit into proof that the membership works. A member who gets one every season has a reason to renew, and a reason to call you first when something does need fixing.

Room by room: the bathroom gave it away

Spot readings from the technician's handheld meter, taken on each visit. The wettest room is usually closest to the problem.

RoomBaselineAfterStatus
Upstairs bathroom81%49%In range
Upstairs hallway76%47%In range
Living room71%46%In range
Kitchen69%47%In range

System checks: the equipment itself was healthy

These tell us how well the heating and cooling equipment is working, apart from the air in the house.

CheckYoursTypicalStatus
Temperature split18°F15–22°FIn range
Refrigerant chargeIn specMaker's specIn range
Condensate drainClearClearIn range
Static pressure0.62 → 0.480.50 or lessIn range

"Typical" ranges are the ones technicians commonly work to. Your equipment maker's specs always come first.

What we did, and what's next

  1. DoneSealed the duct above the bathroomCooled air was leaking out into the ceiling space. Air that leaves the house has to be replaced, so humid outdoor and attic air was being pulled in through every gap. The cold duct was also sweating onto the drywall, which is where the stain on the bathroom ceiling came from. We saw what looked like mold there and recommend a qualified professional check it.
  2. DoneSet the fan to Auto, not OnWith the fan always on, water left on the cooling coil can blow back into the house between cycles.
  3. DoneReplaced the filterIt was clogged, which was choking the airflow (see Airflow).
  4. Your partRun the bath fan 20 minutes after showersShowers were the biggest daily spike in both weeks. This costs nothing.
  5. Every 1–3 monthsCheck the filterHold it up to a light. If you can't see light through it, replace it. Pets and carpet mean sooner.
  6. Next visitRe-check humidity in summerMuggy months are the real test. We'll compare against this baseline.

Words to know

Baseline
Your home's readings before we changed anything. Everything after is compared to it.
Relative humidity
How much water is in the air, compared with the most it could hold at that temperature. 100% would be fog.
PM2.5
Fine particles of dust, smoke and soot. Each is about 30 times thinner than a human hair, small enough to stay floating in the air.
µg/m³
Micrograms per cubic meter: how many millionths of a gram of particles are in a box of air about 3.3 feet on each side.
Static pressure
How hard your blower has to push to move air through the filter and ducts. Think of a garden hose: kink it and the pressure goes up while less water comes out.
Temperature split
How much cooler the air coming out of your vents is than the air going in. It shows the AC is doing its job.
Coil
The cold part inside your indoor unit. Air passes over it, gets cooler, and drops its extra water, which drains away.

This is not medical advice

This report shows what we measured in your home and what the EPA, CDC and others publicly recommend for indoor air. It does not diagnose anything, and it doesn't test for mold. If anyone in your home has allergies, asthma or other health concerns, talk with your doctor about what's right for them. If you see mold, have it checked by a qualified professional.

Sources for the recommendations

  1. EPA: keep indoor humidity below 60%, ideally 30–50%. epa.gov/mold
  2. EPA and CDC: dust mites and mold are common indoor asthma triggers; CDC suggests keeping humidity around 30–50%. epa.gov/asthma · cdc.gov/asthma
  3. Asthma and Allergy Foundation of America: dust mites like humidity above 50%. aafa.org
  4. WHO 2021 air quality guideline for PM2.5: 15 µg/m³ over 24 hours. EPA 24-hour standard: 35 µg/m³. Both are written for outdoor air. who.int · epa.gov
  5. EPA: inhaled fine particles can affect the heart and lungs. epa.gov/indoor-air-quality-iaq
  6. ENERGY STAR: a dirty filter slows airflow and makes the system work harder. energystar.gov
  7. U.S. Department of Energy: damp air makes a home feel warmer than the actual temperature. energy.gov
  8. ASHRAE Standard 55 comfort ranges, as summarized by NC Public Health: about 73–79°F in summer at 50% humidity. nc.gov

Demo company (Anytown Comfort Co.). Modeled on a home from an 8-home pilot; names and hourly readings are illustrative. Not a real customer.

Charlie Kodatt · Former operations and sales leader for PE-backed HVAC, plumbing and electrical companies · More than 3,000 homes as a comfort advisor